XLR Plug Connections: Wiring a Balanced Connector
Three pins, three joints and a locking shell. Wiring an XLR plug is a skill worth learning for anyone maintaining audio equipment.
Quick Answer
| Pin | Wiring | Function |
|---|---|---|
| 1 | Shield or screen | Ground and protection |
| 2 | Hot, positive | Signal in phase |
| 3 | Cold, negative | Signal inverted |
Consistency matters more than the exact colour convention. The same conductor must reach the same pin at both ends.
Soldering Order
Prepare the cable
Strip the jacket, fold the shield back, and twist the two signal conductors.
Tin the conductors
Apply solder to the exposed strands so they hold together.
Solder pin one
The shield goes first, taking the least heat.
Solder pins two and three
Each signal conductor to its pin, keeping joints clean and bright.
Assemble the shell
Ensure the clamp grips the jacket, not the conductors.
Testing Before Use
- Check continuity from pin to pin at both ends.
- Confirm no short between pins.
- Check the shield reaches pin one at both ends.
- Confirm the clamp holds the cable under strain.
- Test in the actual equipment before a session.
Real-World Applications
- Repairing damaged microphone cables.
- Building custom lengths for a rack.
- Terminating installed audio wiring.
- Replacing worn connectors.
Related Guides
For cable selection, read XLR to XLR cable. For microphone cables, see XLR cable guide. For consumer conversion, start with 3.5mm to XLR cable.
FAQ
Which wire goes to which pin?
Pin one shield, pin two hot, pin three cold. Keep the convention consistent at both ends.
Do I need special solder?
Standard electronics solder works. Rosin cored is easiest.
Why is my joint crackling?
A cold solder joint or a clamp that grips the conductors instead of the jacket.
Can I crimp instead of solder?
Some connectors support crimp contacts, which need the correct tool.